WARNING: Allowing excess lubricant in case may affect powder or primer.

Lyman “Quick Slick” Case Lube is a premium, fast-acting lubricant designed for use on cartridge cases prior to resizing. It eliminates messy lube pads and greasy fingers which lead to contaminated primers.

DIRECTIONS FOR USE:
Shake can before using. Periodically shake can for best results.

1. Disassemble sizing die and thoroughly clean inside the die with a solvent degreaser. Other lubricants form a protective barrier and can limit effectiveness.

2. Spray a light coat of Quick Slick inside the die and allow to dry. Reassemble sizing die.

3. Clean and inspect cartridge cases.

4. Place cartridge cases in a loading block or lay out in a single layer on a clean tray such as a cookie sheet or shallow cardboard box.

5. Spray lightly, roll cases over and spray lightly again. When using a loading block, spray one side of cases, reverse block and repeat on other side. Wait about 30 seconds. Cases are then ready to be resized.

6. After resizing, remove lubricant from cases. This can be done in a Lyman Turbo® Tumbler or Turbo Sonic® Ultrasonic cleaner, or by wiping the cases with a cloth.

DANGER: CONTENTS EXTREMELY FLAMMABLE AND UNDER PRESSURE. SKIN AND EYE IRRITANT.